Factory Flooring glossary
The terms you'll come across, explained in plain English.
- Aggregate
- Hard particles such as quartz or aluminium oxide added to resin to create texture and improve slip resistance.
- Arris
- The edge of a concrete joint. Damaged arrises on forklift routes break up and widen joints, and are often repaired with stronger materials.
- Coving
- A curved transition between floor and wall that removes the sharp corner where dirt builds up. Often formed in resin in food areas.
- Damp-proof membrane
- A barrier beneath or within a concrete slab that stops ground moisture rising. Slabs without one may need special primers under resin.
- Diamond grinding
- Using rotating diamond tools to smooth concrete, remove coatings and prepare edges and small areas before resin flooring is applied.
- Epoxy resin
- A two-part resin that cures to a hard, durable surface. It is widely used for floor coatings and self-smoothing floors in dry industrial areas.
- Falls
- The slight slope built into a floor so water drains towards gullies or channels instead of pooling.
- Laitance
- A weak, dusty layer on the surface of concrete formed as it cures. It must be removed before a resin floor is laid, or the resin will not bond properly.
- Pendulum Test Value
- The result of the pendulum slip test, abbreviated PTV. HSE guidance treats 36 or above as low slip potential.
- Polyurethane screed
- A thick resin floor, usually 6–9 mm, mixed with aggregate. It resists heat, thermal shock, chemicals and impact, and is common in food production.
- Primer
- The first coat applied to prepared concrete to seal it and give the resin system a strong bond.
- Scabbling
- A heavy preparation method that chips away the concrete surface to remove thick coatings or high spots.
- Self-smoothing floor
- A resin system poured and spread at 2–4 mm thick that flows to a flat, jointless finish. It suits busy manufacturing and clean areas.
- Shot blasting
- A preparation method that fires steel shot at the floor and vacuums it back, removing laitance and light coatings and leaving a textured surface for resin to grip.
- Thermal shock
- Stress caused by sudden temperature changes, such as hot water on a cold floor. It can crack or debond floors not designed to cope.
Get a free factory flooring quote
Tell us what you need and we'll come back with a clear price.
Request a quote